egghelp.org community

[smooch1502]

Hello,

I've created the bot and started it up successfully. i typed /msg BotName hello

It's responded with that i'm its master etc and i've set a password using pass
But when i try to say anything else whatever to it it doesn't respond

I tried /msg AdminBot invite #help but he doesn't respond with anything at all??

Please help!!

In debug mode i get: [17:09:49] [Daniel!Daniel@xxx.xxx.xxx.xxx] .help userinfo
if i type .help userinfo.

But the bot still does not respond with anything??

[nml375]

All msg commands require you to supply the password along with the command, so the invite command would be:
/msg AdminBot INVITE yourpass #help
Depending on your config settings, your eggdrop may or may not notify you of an incorrect password, default is not to notify you.

Also, there should be no . prefix for msg-commands; that only applies to dcc partyline commands. And finally, msg-commands are a tiny subset of the commands available through the dcc chat partyline.
_________________
NML_375, idling at #eggdrop@IrcNET