This is the new home of the egghelp.org community forum.
All data has been migrated (including user logins/passwords) to a new phpBB version.


For more information, see this announcement post. Click the X in the top right-corner of this box to dismiss this message.

DCC SEND errors on 1.8.4 (raspberry pi)

General support and discussion of Eggdrop bots.
Post Reply
j
jerFR
Voice
Posts: 1
Joined: Thu Jan 10, 2019 1:10 pm

DCC SEND errors on 1.8.4 (raspberry pi)

Post by jerFR »

Good evening,
I compiled 1.8.4 on rpi ( armv7 arch). All went well (with tcl 8.6).
i can connect to the network , join channel
I have an error with files DCC sent to the bot.
error message: EEINPROGRESS

looking through debug messages, i suspect a bad address resolution
i see this as host port : 0.0.0.0:4
Please note the distro version 1.6.21 doesnt yield this issue.
I can send the config.log if requested.
Thanks, and best regards,
Jerome
User avatar
ComputerTech
Master
Posts: 399
Joined: Sat Feb 22, 2020 10:29 am
Contact:

Post by ComputerTech »

i have a dcc problem also on freenode only i just use /ctcp (botnick) chat
not sure if it will solve your problem but give it a go ;)
ComputerTech
Post Reply